A video was promised, here it is!
Sunday, April 4, 2010
High Current Motor Controller Shield in Action!
Labels:
arduino
,
high current motor controller shield
,
video
Subscribe to:
Post Comments
(
Atom
)
Hi! nice job. I do have a question about the code. I use the same drivers (two single), however I have some issues with changing the direction of the motor. I do change values on pins, but sometimes one of the motors doesn't switch off. I am not sure if the problem is with my code or with the battery /or something else. can you send me, or post your code?
ReplyDeletekind regards,
Michael
lubosmichal@gmail.com
This is great! im actually trying to do a similar project running a motor to power a scissor lift. I was just wondering how you connected the arduino to the VNH2SP30, basically what pins from the arduino are connected where on the motor controller board? If you could help me out that would be great.
ReplyDeleteThanks,
Devin
baysidestriker11@yahoo.com
Check out http://ilektron-x.blogspot.com/2011/02/high-current-motor-controller-shield.html for the schematics and a simple example sketch.
ReplyDeleteGet a $50 free chip bonus at Slots of Vegas
ReplyDeleteSlots of Vegas Online หาเงินออนไลน์ Casino Review - Welcome Bonus: Get $50 free chip bonus at Slots of Vegas Casino! Read on to learn more bsjeon.net about gri-go.com the latest deccasino Rating: 3.5 · Review by Casino Roll 바카라 사이트